top of page
GALLERY
Machining Photos
Fabrication/Weld-Building
Bulldozer Hub
Prototype Fab 1
Prototype Fab 2
Prototype Fab 3
Weld Build 1
Weld Build 2
Weld Build 3
Weld Build 4
Weld Build 5
Weld Build 6
Hardened Steel 1
Ceramic cutters can handle immense heat
Hardened Steel 2
Hardened Steel 3
Threaded Ring 1
Early steps of turning a solid disk into a threaded ring nut
Threaded Ring 2
Rough-boring complete Pictured with a 1/2" ratchet
Threaded Ring 3
Thread cutting oil just begins to cause smoke at the cutting tip
Threaded Ring 4
Close-up of finished ring
Machined Parts
This assembly of aluminum parts has an uncolored anodized finish
Large Shaft Turning
Chips pour off of a 6" diameter shaft
Long Part Machining
Our largest lathe can handle parts up to 80" long
bottom of page